USB 2.
1. Characteristics Support SATA spread-spectrum transmitter Support SATA II Asynchronous Signal Recovery (Hot Plug) feature Compliance with USB 2.
. Tips for HDD INSTALLATION For 2.5’’/3.5’’ SATA HDD (1) Have SATA Hard Drive to connect with ER CABLE. (2) Have the external Power Adapter connect with USB 2.0 TO IDE/SATA ADAPTER CABLE. (3) Have USB 2.0 TO IDE/SATA ADAPTER CABLE connect with and your computer, then power on, your computer system will detect the SATA HDD.
For 3.5’’ IDE HDD (1) Have the 3.5’’ IDE HDD connect with USB 2.0 TO IDE/SATA ADAPTER CABLE. (2) Have the external Power Adapter connect with USB 2.0 TO IDE/SATA ADAPTER CABLE. (3) Have USB 2.0 TO IDE/SATA ADAPTER CABLE connect with your computer, then power on, your computer system will detect the IDE HDD.
For 2.5’’ IDE HDD (1) Have 2.5’’ IDE HDD connect with USB 2.0 TO IDE/SATA ADAPTER CABLE. (2) Have USB 2.0 TO IDE/SATA ADAPTER CABLE connect with your computer, then power on, your computer system will detect the IDE HDD.
NOTES: Our product USB 2.0 TO IDE/SATA ADAPTER CABLE can support 2.5’’/3.5’’ SATA & IDE HDD synchronously, please refer to the below application image.
4. Software Installation Before installation, please connect the hard disk to the USB 2.0 to SATA II + IDE Adapter Cable Windows 98SE After installing the driver, please restart the computer, and then plug the USB 2.0 to SATA II + IDE Adapter Cable into the computer. It’s very important. 1) Please put the enclosed CD into the CD-ROM, and doubly click “setup.exe” 2) The driver is beginning to install 3) When the following screen displays, click ‘Finish’ 4) Please plug USB 2.
5. Verification Please track the path "My computer” and "My computer” -- > “System Properties” -- > “Device Manager" and expand the item "Hard disk controllers”, you should meet the following screen.
6. Remove Driver 1) Pull out USB 2.0 to SATA II + IDE Adapter Cable from the USB port of the computer 2) Then, Open the program "Add or Remove Programs", according to the following pass: Start/ Control Panel/ Add or Remove Programs. 3) When the following screen displays, Please click ‘ JMicron USB Disk Driver’, and then click “ADD/Remove…”, to begin canceling. 7. If you use an all new HDD 1) Please use " Fdisk " to set the capacity of your HDD, but this will destroy all the data in the HDD.
8. FAQ Q: I could see the icon at the right down comer on the screen, but I still couldn't find my external HDD. A: a. Please make sure your HDD has been installed correctly. b. Please make sure your HDD has been set in "Master" position, c. Please make sure you have installed correct driver for this USB HDD. d. Please make sure your HDD has been formatted. If no, please format your hard drive first. e.
