User's Manual
Table Of Contents
- Mark III Directional Drilling Locating System
- Table of Contents
- Table of Contents (Cont.)
- Table of Contents (Cont.)
- Safety Precautions and Warnings
- Safety Precautions and Warnings (Continued)
- Dear Customer:
- 3-3000-00b-F.pdf
- 3-3000-00c-F.pdf
- Receiver
- Display Window Icons
- On/Off
- Receiving the Transmitter’s Signals
- Clicking vs. Holding the Trigger
- Changing the Receiver’s Channel Setting
- Changing the Depth Measurement Units (English vs. Metric)
- Battery Status Display for Receiver and Transmitter
- Warning Tones for Transmitter Overheat
- Ultrasonic Function
- Calibrating the Receiver
- Using Depth Antenna Plumb Line to Mark Locate Points
- Finding Firmware Version
- 5.0 Series Firmware Functions
- Receiver
- 3-3000-00d-F.pdf
- 3-3000-00e-F.pdf
- 3-3000-00f-F.pdf
- 3-3000-00g-F.pdf
- 3-3000-00h-F.pdf
- 3-3000-00i-F.pdf
- 3-3000-00j-F.pdf
- Locating
- Locating Mode
- Locate Points (FNLP & RNLP) and Locate Line (PLL)
- Handling the Receiver
- Distance Between FNLP and RNLP Due to Depth, Pitch, and Topography
- Using Plus/Minus Indicators for Locating
- Locating the Transmitter from the Drill
- Locating the Transmitter from the Front
- Method for Confirming Position
- Locating on the Fly
- Off-Track Locating
- Splitting the Front and Rear Negative Locate Points
- Four-Turn Technique
- Calculating Depth Based on Distance Between FNLP & RNLP
- Running off Pitch or Calculating Depth from Pitch
- Transmitter’s Signal Shape
- Antenna Configuration
- Signal Reception
- Front and Rear Negative Locate Points
- Positive Locate Line Above Transmitter
- Locating
- 3-3000-00k-F.pdf
- 3-3000-00l-F.pdf
- 3-3000-00m-F.pdf
- 3-3000-00n-F.pdf
- 3-3000-00o-F.pdf
- 3-3000-00p-F.pdf
®
19625 62nd Ave. S., Suite B-103 y Kent, Washington 98032 USA y 425-251-0559 or 800-288-3610 y Fax 253-395-2800
www.digitrak.com (Web Site) DCI@digital-control.com (E-mail)
Page 1 of 2
DIGITAL
CONTROL
INCORPORATED
REMOTE TELEMETRY LICENSE
The attached license is required by the United States Federal
Communications Commission (“FCC”) for operation of the
DigiTrak
®
Remote Receiver. DigiTrak
®
Remote Receivers are iden-
tified by the orange arrow and the FCC ID #KKG007 on the label
below the battery compartment door.
This license was approved by the FCC under an overall license
issued to Digital Control Incorporated. An operator of a DigiTrak
®
Remote Receiver in the United States is no longer required to
apply for a separate personal license as previously required.
This license authorizes operation of the DigiTrak
®
Remote Re-
ceiver in the United States only. The DigiTrak
®
Remote Receiver
shall only be operated in accordance with the rules and regula-
tions of the FCC and as outlined in the owner’s manual accom-
panying this equipment. No modifications may be made to the
DigiTrak
®
Remote Receiver or other DigiTrak
®
equipment.
It is the operator’s responsibility to obtain proper licensing for
operation of the DigiTrak
®
Remote Receiver outside of the United
States.