Inc N Scale Function Decoder - Manual

Digitrax SoundFX™ decoders will operate on smooth DC power. The sound

will not start until approximately 5 volts is applied to the track and there will

be no “start up sound.”

SDN144K1E Troubleshooting

If the sound does not start in the decoder

1. Make sure you have selected the locomotive address on a throttle. The

sound will not run unless the locomotive is addressed in the system. Make sure

F8 is OFF.

2. Check your installation to make sure the decoder is installed properly.

If the sound output sounds distorted

Complete Train Control

Run Your Trains, Not Your Track!

Function # Used For Notes

F0 Lights

F1 Bell

F2 Horn/Whistle CV150 selects horn

F3 Coupler crash Auto coupler/brake set by

CV151 max speed

F4 Air feature disable F4 off enables pop-off,

drier and starts compres-

sor

F5 Diesel = Dynamic brake

Fans

F6 Diesel = Notch Up Notch UP if CV155=01 or

F7 Crossing Gate Airhorn

or;

Diesel = Notch DOWN

Notch DOWN, if

CV155 = 01 or 02

(Crossing Gate Horn active

if CV155=0)

F8 Mute Control F8 ON is muted

F9 Brake squeal

F10 Crossing Gate

Airhorn Sequence

F11 Handbrake

F12