Inc Kato SD40-2 N Scale Mobile Decoder - Manual

Function Outputs on the DN163K1C

The DN163K1C is set up at the factory to control six functions. The unit is

prewired with two white LEDs set up for directional lighting as F0F/F0F+ for

the front light and F0R/F0R+ for the rear light. Functions F1 (Green), F2

(Violet), F3 (Brown) and F4 (White/Yellow) can be used by soldering a wire

from the pad for the function you wish to use to the lamp (or other function)

you wish to control. The wire colors indicated are the standard color code used

in the industry (you can use any color you like). These colors are important if

you plan to use function remapping.

CAUTION: When adding function wires, be very careful that the wires you

add do not come into contact with any other pads or components on the

board where they might create a short circuit, damage the board and void the

warranty.

All six function outputs can be easily set up with Digitrax FX

lighting effects

or as standard on/off functions with the following operational qualifiers:

1. Forward or Reverse direction of travel, or

2. Whether F0 is on or off, or

3. Both direction of travel and whether F0 is on or off, or

4. Whether the locomotive is stopped or moving.

Complete Train Control

Run Your Trains, Not Your Track!

Figure 5: Connecting More Functions to Your DN163K1C Decoder

Top of DN163K1C Decoder

FRONT OF LOCO

F3 (Brown)

F2 (Violet)

+common

(Blue)

F1 (Green)

F4 (White/Yellow)

Motor Clips

F0F+

F0F (White)