Inc Kato SD40-2 N Scale Mobile Decoder - Manual

To change the decoder address:

1. Place the loco on the programming track. Go into Program Mode on your

system. On DT400 press PROG. On DT300, DT100 & DT200 press

RUN/STOP & FN/F0.

2. Choose AD2 for 2 digit addressing or AD4 for 4 digit addressing (DT300 &

DT400). (Ad for DT100 & DT200, see set manual for 4 digit instructions).

3. Choose the address you want to set up for the decoder.

4. Complete address programming. On DT400 press ENTER. On DT300,

DT100 & DT200 press SEL.

Note: CV29 must also be programmed to enable 4 digit addressing, this is

done automatically by the DT300 & DT400 but not on earlier throttles.

Digitrax LocoMotion

System

Your locomotives look like the real thing, now you can make them run like the

real thing, too. Digitrax decoders incorporate torque compensation for smooth

as silk operation. You can also program CVs that control momentum, 3 step

and 128 step speed tables, switching speed, normal direction of travel,

scaleable speed stabilization and more to take full advantage of the Digitrax

LocoMotion

System.

Speed Tables-How the Loco Responds to the Throttle

There are two types of speed tables: 3 Step Tables and High Resolution 28 Step

Tables. Please see your Decoder Manual for a discussion of the 28 Step Tables.

The 3 Step Tables are set up by programming 3 CVs: Start Voltage (CV02), Mid

point Voltage (CV06) and Max Voltage (CV05). These values are set at 000 at

the factory. All have a range of values from 000 to 255. We recommend the fol-

lowing CV values as a starting point for experimenting with speed tables.

Complete Train Control

Run Your Trains, Not Your Track!

Loco Type V Start V Mid V Max

CV02 CV06 CV05

Switcher

Concentrated low speed. Limited top 002 038 064

speed

Road Switcher

Prototypical top speed w/evenly 002 048 098

distributed curve from 0 to top speed

Mainline Loco

Quick increase to cruising speed then 002 128 154

levels off to prototypical top speed.