Owner`s manual
Digitone Call Blocker™ Setup
Thank you for choosing Digitone’s Call Blocker
™
Model 10 as your Personal Communicator. Digitone
Communications is confident that you will find Digitone’s unique preset features and flexibility are just the
answer for your communications needs. Just connect your telephone and you’re ready to go. You don’t
need to set any codes as Digitone’s Call Blocker can operate right out of the box.
No Battery Backup is Needed - If there is a power outage, all of the program settings remain intact.
1. Connect the supplied line cord to your telephone wall jack and then to the Line Port on the Call
Blocker. You must connect the Line cord and your Phone to the correct ports in order for the Digitone
Call Blocker to operate properly. Initially, “Line In Wrong Port” will show on the display until the Line
cord is plugged into the LINE port. “Check Cords” will display if the Line cord is disconnected afterwards.
2. Plug the small end of the Power Supply into the port labeled "24VDC" on the Call Blocker, next plug in
the Power Supply to a 120/240VAC wall receptacle.
3. Connect your combo Phone/Answer Machine system to the Phone Port of the Call Blocker and set to 3-
5 rings. Note if you are using Voice Mail services from your phone company, then don’t enable any
answering devices there in your home or office.
4. Connect an optional answer machine to any wall phone connector and set the answer delay to 4-6
rings, or 1 ring greater than the answering device in the Phone port. This separate answer machine will
capture any uninvited calls not answered by the Combo Phone/Answering device in the Phone port.
Standard Caller ID Display
Automatic Caller ID Call Routing
Caller ID service from your phone company is required for Digitone’s Call Blocker to work. The first call to
your Call Blocker unit will initialize the clock and calendar to the current date and time. Automatic call
routing will begin to work right after the first call when Caller ID information is displayed.
Viewing Call History The left Up arrow button displays the previous calls or Top of List. The right
button Down arrow button displays the last call or End of List.
Clearing Display
To remove a single number from Call History, use the Up or Down arrow keys to select the number you
want to remove. Notice the number has dashes between the digits, Ex. 602-555-1234, Press and hold the
Block Button for 3 seconds, then see “Release Button”. Release the button to clear that displayed call.
To Remove the entire Call History, if a number has dashes between the digits, wait until the dashes
are removed, Ex. 6025551234 and only the number shows, then Press and hold the Block Button for 3
seconds, you will then see “Release Button”. “CID List Deleted” will then display, clearing all call history.
1