Owner`s manual

(maximum of 6) until you hear a Beep, then enter * and hear <beep> <beep>, hang-up. Try to enter

programming again with # # and hear <beep>.

Troubleshooting

Caller Lists

You can check to see if you have stored Invited or Blocked caller lists by just taking the phone off the

hook and then hanging back up. Right after you hang-up, the front two green lights will come on for a

second to let you know that it has stored numbers. If you have stored only Invited callers, then just the

left green light will come on. If you have stored only Blocked callers, then just the right green light will

come on.

Testing the PrivacyCall for Caller ID Reception

To check if you are getting good Caller ID reception, call into the PrivacyCall from an outside line and see

if the display shows the call. After this call has settled and with the Left Red light steady, press the

Yellow button on the front panel once and watch to see if the Left Green light flashes five times. If so,

then you have a good connection. If however, the Right Yellow light flashes five times then the

PrivacyCall did not either receive the data or is not compatible with your phone company.

Front Panel Caller ID Indicators

Front view of the PrivacyCall showing the Front view of the PrivacyCall showing the

Green indicator for good Caller ID reception Yellow indicator for bad Caller ID reception

Dialing Monitor

You can monitor inbound calls by watching the Left Yellow light flash as your caller enters touch tones

during the outgoing message or any other time. It also can be used to show if the controller is receiving

the touch tones as you dial. If you ever lose the ability to get your phones to ring with an access code

entry or cannot enter programming, then this would be the first place to check. Just pick up the phone

and dial any numbers and watch the Yellow light flash with the dialing. If it doesn’t flash then the unit

needs repairing.

User Settings Reset

Sometimes you might forget your user settings, like port access codes and want to start over. You can

reset the PrivacyCall to factory with the Code 99. Just enter programming with # # hear <beep> then

99 and hang-up. This will not erase your OGM’s or Caller Lists.