RPx400 USB Drivers and Software Installation Guide
Congratulations on your purchase of a DigiTech RPx400. This installation guide contains the information to install the required USB drivers, X-Edit editor/librarian and Pro Tracks recording software for use with the RPx400. Please follow these instructions carefully to ensure smooth installation of each of these components. A. Installing Pro Tracks 1. Start your computer. Close any open programs you have running. Place the Pro Tracks CD-ROM in your CD-ROM drive. 2.
automatically appear (if installation does not start automatically, go to Start>Run, click on Browse, type d:\instmenu.exe (where d:\ is your CD-ROM drive), and click OK. 7. Now select USB Audio MIDI Drivers from the menu. You will see the following window appear: 8. Click Next. Installation of the drivers could take several minutes.
11. Click Continue Anyway and you will see: 12.
13. Click Continue Anyway and you will see: 14. Click Finish. The RPx400 USB driver installation is now complete. Windows 2000 Users NOTE: DO NOT connect the RPx400 to your Windows 2000 computer until AFTER the DigiTech USB drivers are installed or it may cause instability in Windows. 1. Make sure you DO NOT have the RPx400 USB plugged into your computer. 2. Put the X-Edit CD into your CD-ROM drive.
5..Click Yes and you will see the same window appear one more time. Click Yes and you will see: 6. Click Finish. 7. Connect the RPx400 to the computer with the included USB cable. The following window will appear: 8.
9. Click Finish and you will see: 10. You DO NOT need to restart your computer yet. Click No and you will see: 11.
12. Click Finish and you will see: 13. You DO NOT need to restart your computer yet. Click No and you will see: 14.
15. Click Finish and you will see: 16. Click No. Repeat steps 14 and 15 once more. Then you will see: 17. This time click Yes and your computer will restart. The RPx400 USB driver installation is now complete. C. Setup Windows Audio and MIDI When we installed the DigiTech USB Audio and MIDI drivers,Windows may have automatically selected them as your default audio and MIDI outputs. This means that your Windows sounds will be sent to the RPx400.
These options only need to be changed once now that the drivers are installed. Later we will change the settings in Pro Tracks to use the RPx400 for audio and MIDI. At this point you are ready to use the RPx400 to record with Pro Tracks. You can continue to the next section to install the X-Edit/Librarian. If you are anxious to record, skip the Setting Up the RPx400 MIDI Section D. Install DigiTech X-Edit Editor/Librarian Installing X-Edit allows you to edit and store your presets on your computer.
X-Edit is now installed on your computer. If you disabled or un-installed your antivirus software, you can now reinstall or re-enable it. If you want to edit presets, make sure that the RPx400 is powered on and connected to your computer with the USB cable. Then you can start X-Edit. E. Setting Up the RPx400 MIDI 1. Start Pro Tracks. The first time Pro Tracks is started, the Wave Profiler utility will check and configure you current audio I/O devices. Click OK when these tests have finished. 2.
5. Click the OK button when the window stating changes will be saved upon re-start appears. 6. Close Pro Tracks. When you are prompted to save changes, click No. 7. Re-start Pro Tracks. 8. Close the Tip of the Day and Quick Start windows if they appear. 9. From the Pro Tracks menu bar, select Options>Audio. 10. Verify that the Playback and Record Timing Master settings have DigiTech USB 1-2 In/Out selected. If not, select these now. 11. Set the number of Virtual Mains to 2. 12.
