Installation guide

5
Click VST Audio System and select DigiTech RP350 In/Out (2) as the
ASIO Driver (as shown below). DO NOT select DigiTech RP350 In/Out (1).
Cubase
®
LE 4 will now ask you if you would like to switch the driver. Select
Switch then OK.
Mac OS 10.4.x users only: After selecting RP350 In/Out (2) in the Device Setup
panel, you may need to verify that your device inputs are active. To do this, follow these
steps:
Select Device>VST Connections from the menu bar.
When the VST Connections panel appears, click the Inputs tab.
The box under the Audio Device column may say “Not Connected.” If it
does, click in this box and select DigiTech RP350 In/Out (2) to enable the
device inputs.
You are now ready to start recording with Cubase LE 4.
2.
3.
1.
2.
3.