User Guide

39
Factory Reset
This function resets the RP250 to its original factory settings. This procedure erases all custom
User presets, and recalibrates the Expression Pedal.
ATTENTION: Performing this function will erase all user-programmed data. All
such data will be lost forever! Be sure you want to erase the memory and start fresh
before continuing with this procedure.
The procedure for performing a Factory Reset is as follows:
1. Press and hold the Store button while powering up the RP250.
2. When the display prompts you with , release the Store button, which is now flashing.
3. Press and hold the flashing Store button for 3 seconds until  appears in the display and
release. The Expression Pedal calibration procedure now commences.
Expression Pedal Calibration
The Expression Pedal on the RP250 needs to be recalibrated for use after a factory reset has been
performed. This calibration procedure is automatically entered after a factory reset procedure.
(You can also initiate the calibration procedure by pressing and holding both Footswitches for
approximately 5 seconds.) In the event the Pedal’s calibration fails, or if the Pedal does not function
properly, it can be re-calibrated using the Pedal Calibration procedure. This will not erase the
User presets. The procedure for Calibrating the Expression Pedal is as follows:
1.
Press and hold the Up/Down Footswitches until  appears in the display (
and  will be displayed before  is accessed)
2. When the Display prompts you with , rock the Expression Pedal forward (toe down)