User Guide

The RP14D has several extremely flexible Amp and acoustic Guitar Models. These Models are capable of producing emulations of popular
tube amps and effects pedals giving you the smoothest of the blues tones to the full shred gain of a cranked up stack, as well as acoustic
guitar simulations. The Models include two channels (red and green). Separate Models, Gain, EQ, and Level settings can be assigned to
each. You can then toggle between Amp Channels using the Channel footswitch. The LED above the Channel footswitch will light either red or
green indicating which channel is active. The Amp Model Effect occupies two columns on the Matrix. The first press of the Edit button will
automatically default the RP14D to the first Amp Model column. Using the Value Up or Down buttons will select the Type of Amp Model that
you want. The Left and Right Parameter Select buttons provide access to the two Amp Model columns, and the Up and Down Parameter
Select buttons are used to select the Parameters of the Amp Models.
Note: For the best results with the acoustic simulators, the neck pick up is recommended.
The following parameters can be found in the two Amp Model columns:
Column One
Amp Type Selects the type of Amp Model used. The Models in the RP14D are:
Stac - a modern American Stack blue - an authentic blues tube tone
rEct - a Dual Rectifier tuin - a classic American Twin combo
Hign - a high gain distortion CLSA - a British Class A combo
fu22 - a full frequency fuzz pedal CLn - no distortion, but active EQ
brit - a modern British Stack AC1, AC3 - acoustic guitar simulations for humbuckers.
bout - a modern Class A combo AC2, AC4 - acoustic guitar simulations for single coil.
Amp Channel Selects between the two channels, grn (green) and red (red).
Column Two
Gain Controls the amount of distortion produced by the RP14D. High settings produce greater distortion drive
for effortless soloing, while low settings offer better nuance and dynamic control. Ranges from 1 to 11.0.
The Gain control parameter is not available in the Acoustic or Clean preamp types.
*Note: These Parameters can be assigned to the Expression Pedal. See page 11 for more information on Expression Pedal
assignments.
Amp Model Column One
Parameters
Displayed Values
Amp Type
grn - red
Amp Channel

Parameters
Displayed Values
Gain *
0...10
Mid Range 0...10
Bass
1.0...11.0
Treble 0...10
Level 0....100
Amp Model Column Two

CLn... AC4 (see list below)
RP14 UserÕs Guide Section Three - Effects and Parameters
12