User Manual

3
4. Decay Knob
Controls the length of time it takes for the reverb to fade out.
5. Input 1 (Mono)
Use this jack when only a single connection is needed. Connect your instrument, the output of a
pedal, or an amp effects send to this jack. Signals are heard at both outputs when only this jack is
used.
6. Indicator LED
Lights when the effect is turned on.
7. Input 2
Connect a second input to this jack for stereo operation. Inputs 1 and 2 are processed separately
through the stereo reverb effect then fed to Outputs 1 and 2, keeping true stereo separation
between channels.
8. Footswitch
Turns the effect on and off.
9. Output 2
Connect this output to the input of a second guitar amplifier when a second amp is being used.
10. Output 1 (Mono)
Connect this output to the input of a single guitar amplifier or amp effects return.
11. Liveliness Knob
Controls the amount of high frequency response in the Reverb’s effect signal.
12. Level Knob
Controls the reverb level.
MAKING CONNECTIONS/APPLYING POWER
To connect the Polara pedal to your rig:
1. Turn down the amplifier’s master volume control.
2. Make all audio connections to the Polara as shown in ‘Connection Diagrams’ on page 4.
3. Connect the appropriate HARMAN power supply (sold separately) to the POWER input connector
and connect the other end to an available AC outlet.
4. Strum your guitar and gradually increase your amplifier’s master volume control until the desired
level is achieved.