Owner`s manual
Note that a cursor appears under the 0 in HOLD TIME.
This is the seamless Program change setup menu. This menu is Program specific; each Program
can be set up to behave differently using this setup screen.
IMPORTANT: The seamless Program change setup menu only shows up WHEN THE CUR
RENTLY LOADED PROGRAM USES A SINGLE S-DISC ALGORITHM.
If this menu does not appear using the procedure described above, check to
make sure that the Program uses a single S-DISC Algorithm.
• Using the Data wheel, change HOLD TIME to the desired value.
• Press Function key [2] once. The cursor moves to RAMP TIME.
• Use the Data wheel to select the desired value.
• When you’re finished, press [UTILITY] to exit.
The maximum available RAMP TIME is 10 seconds. HOLD TIME also has a maximum setting
of 10 seconds, but also includes an INFINITE option that holds the previous Program indefinite-
ly until the next Program change.
IMPORTANT: The INFINITE option is not
an infinite repeat for delays or reverbs. Infinitely
repeating effects must be set up in the Parameter menu for each Program. The
INFINITE option allows the infinitely repeating effect to continue without
ramping down after a Program change.
87
Section 7 - Other Utilities
GSP-2101 Artist Owner’s Manual
Other Utilities