Owner`s manual

Int. Exp pedal CC: The Expression pedal of the Control One can also send MIDI CC
data . This switch function allows you to re-assign the MIDI CC assignment for the
Expression pedal (i.e. if the pedal were assigned to send CC4 data, it could be temporari-
ly re-assigned to send CC7 using the Int. pedal CC function).
The procedure for setting up a footswitch function is as follows:
• Press the [UTILITY] key once. The display reads:
• Press Function key [2] once. The display reads:
• Press Function key [1]. The display reads:
This screen tells you that Footswitch 1 in Bank 1 of the Control One is set to recall
Program 1 of the GSP-2101 Artist.
• The cursor appears under PROGRAM NUMBER. Using Function key [3] or the Data
wheel, locate the footswitch function you wish to use.
• The display may read:
• Press [UTILITY] to exit the Foot Controller setup menu.
Assigning MIDI Control to the Expression Pedals: This series of menus and submenus allows
MIDI setup of the Expression pedal(s) of the Control One. There are several things you must do
in order for the Expression pedals to work properly with MIDI.
Assign CC Number
- This option allows you to choose the MIDI CC numbers you want
to use for sending continuous control messages. From the factory, the Expression
pedal(s) are not pre-assigned to any MIDI CC number. To assign which CC number is
sent from the Expression pedal(s), do the following.
¡Bank Number: 1
™Patch Number: 1
£Program Up *
¡Bank Number: 1
™Foot Switch: 1
£Program Number: 1
Lead On Me
¡Patch Assignment
™LED Assignment
£Exp Pedals and
CC Xmit Setup ≥
¡Output Mode: Stereo
™Foot Controller
76
Section 6 - The GSP-2101 and the Control One
GSP-2101 Artist Owner’s Manual
2101 & C1