Owner`s manual
Whammy™
Effect On / Off
: Turns the Module on or off. When the Module is turned off, its
Parameters are not displayed, but signal will continue to pass through the module. To
see the Parameters, you must turn the Module on.
Pedal Down Pitch
: Sets the amount of pitch shifting when the pedal is down (the
“down” position is when the toe of the pedal is down). Varies from -24 to +24 semi-
tones. This Parameter appears only in the Programmable Whammy.
Pedal Up Pitch
: Sets the amount of pitch shifting when the pedal is up (the “up” posi-
tion is when the toe of the pedal is up). Varies from -24 to +24 semitones. This
Parameter appears only in the Programmable Whammy.
Pedal Down Detune
: Sets the amount of detuning when the pedal is down. Varies from -
100 to +100 cents. This Parameter appears only in the Programmable Whammy.
Pedal Up Detune
: Sets the amount of detuning when the pedal is up. Varies from -100
to +100 cents. This Parameter appears only in the Programmable Whammy.
Whammy Function
: Selects the function of the Whammy Module. There are 16 func-
tions available in regular Whammy Modules. They are as follows: ShallowDetune, Deep
Detune, Up 1 Octave, Up 2 Octaves, Down 2nd, Down 1 Octave, Down 2 Octaves, Up
2nd-Up 3rd, Up m3rd-Up3rd, Up3rd-Up4th, Up4th-Up5th, Up5th-Up6th, Up5th-
Up7th, Dn4th-Dn3rd, Dn5th-Dn4th, and Dn12-Up12. This Parameter does not appear
in the Programmable Whammy.
Whammy Pedal Value
: The WHAMMY PEDAL VALUE Parameter reflects the current
setting of the continuous control device. This Parameter can be modified manually
using the Data wheel, or by using a continuous control device (such as the DigiTech
Control One) to perform the Whammy function. As the Parameter is modified, the
pitch of the original note will change in intervals according to the setting of WHAM-
MY FUNCTION. Ranges from 0 to 100.
Tracking (Tones)
: Controls the sound quality/tracking speed of the pitch shifted materi-
al. This control should be set according to the amount of pitch shifting being performed.
That is, as the pitch shift interval increases, TRACKING should also be increased to
optimize sound quality. Each value setting of this Parameter is optimized for specific
ranges of pitch shifting. For instance, if the value displayed reads 6-10, it means that the
setting of PEDAL DOWN PITCH or PEDAL UP PITCH should be between 6 and 10
semitones from the original note for best sound quality. This Parameter does not appear
in the Programmable Whammy. Ranges form 0-1 to 12-24.
Whammy Level
: Controls the overall level of the Whammy effect. Varies from 0 to 100.
This Parameter appears only in the Programmable Whammy.
Dry Level
: Controls the level of the dry (unaffected) sound. Ranges from 0 to 100. This
Parameter appears only in the Programmable Whammy.
35
Section 3 - Editing Effects
GSP-2101 Artist Owner’s Manual
Editing Effects