Owner`s manual

LFO Speed: Controls the speed of the chorus sweep. The higher this is set, the faster
the chorus oscillates back and forth. This will also cause the chorus to modulate deeper
(as it goes faster). Variable from 00.06 to 16.00 Hz.
LFO Depth
: This Parameter sets the sweep depth (intensity) of the chorus. Variable
from 0.00 to 40.00 milliseconds.
LFO Waveform Type
: Controls the LFO (low-frequency oscillator) waveform pattern of
the chorus effect. SINE produces a smooth sine wave-type chorus with even transitions
in and out of the turnaround points. TRIANGLE is a linear chorus effect, and ramps the
pitch of the wave up and down, with no slowing at turnaround points (your ear will per-
ceive this almost as detuning instead of chorusing). LOGARITHMIC and EXPONEN-
TIAL waveforms are more dramatic in their effect on the signal, producing a bouncy
oscillation. See fig. 3-11.
Fig 3-11
Flangers - The GSP-2101 Artist also offers a diverse selection of flangers, each unique in char-
acter and sound. Flangers are much like choruses except that the chorused signal is fed back into
the input, causing the sound to curl or comb. Like the chorus, the dual flanger uses two flanger
voices whose modulation is set 180 degrees out of phase, while the 4-phase flanger Module uses
four voices modulated 90 degrees out of phase. Flanger Parameters are as follows:
Effect On / Off
: Turns the Module on or off. When the Module is turned off, its
Parameters are not displayed, and signal will not continue to pass through the module.
To see the Parameters, you must turn the Module on.
Flanger Level
: Controls the overall level of the flanger. Variable from 0 to 100.
Delay Time
: Sets the amount of delay present in the flange effect. Varies from 0.00 to
10.0 milliseconds.
Regeneration
: Controls the amount of flanged sound fed back to the input of the
Module. High regeneration settings produce dramatic and interesting unnatural effects
like your guitar curling in a tube. Varies from -99% to +99%. This Parameter can also be
turned off.
LFO Speed
: Controls the speed of the flange sweep. The higher this is set, the faster the
flanger oscillates back and forth. This will also cause the flanger to modulate deeper (as
it goes faster).Variable from 0.06 to 16.00 Hz.
LFO Depth
: This Parameter sets the sweep depth (intensity) of the flange. This
Parameter sets the sweep depth (intensity) of the chorus. Intensity is also changed as the
LFO Speed changes (faster = deeper). Variable from 0.00 to 40.00 milliseconds.
0 ms
TIME
CHORUS DEPTH
CHORUS WAVEFORM: SINE
40 ms
0 MS
TIME
CHORUS DEPTH
CHORUS WAVEFORM: TRIANGLE
40 ms
0 ms
TIME
CHORUS DEPTH
CHORUS WAVEFORM: LOGARITHMIC
40 ms
0 ms
TIME
CHORUS DEPTH
CHORUS WAVEFORM: EXPONENTIAL
40 ms
31
Section 3 - Editing Effects
GSP-2101 Artist Owner’s Manual
Editing Effects