Owner`s manual

Repeat Hold: This is the infinite repeat Parameter. When turned on, the delay taps will
repeat indefinitely until the REPEAT HOLD Parameter is disengaged. See fig. 3-9.
Fig 3-9 Fig 3-10
Samplers - The GSP 2101 Artist offers several sampler Modules in different time ranges and
input/output routings to maximize flexibility and usefulness. All Modules offer 48 kHz sample
rates for professional studio-grade samples. Sample recording and playback can be triggered from
the optional DigiTech Control One, via MIDI (through continuous controller linkages), or by
audio sources. Sampler Module Parameters are as follows:
Effect On / Off
: Turns the Module on or off. When the Module is turned off, its
Parameters are not displayed, and signal will not continue to pass through the module.
To see the Parameters, you must turn the Module on.
Manual Trigger
: This Parameter allows manual playback triggering of the sample in
memory. To trigger the sample, simply press the Function key located under this para-
meter on this screen.
Record Mode
: Sets the mode of operation for the sampler Module. When set to
RECORD, the sampler will record a new sample into memory when triggered. When set
to PLYBCK, the sample in memory will be played back when triggered. After you record
a sample, this Parameter is reset to PLYBCK.
Sample Start Point
: Determines the point at which the recorded sample starts playback.
This Parameter can be used to eliminate unwanted sounds at the beginning of the sam-
ple, such as empty space (silence), fret noise, amplifier buzz, wrong notes, etc. Each time
this Parameter is changed, the sample is retriggered. This allows easy editing of start
sample points (try turning the Data wheel!). This control can be set at any point in the
sample below the setting of SAMPLE END. Like the DELAY TIME Parameter of delay
Modules, SAMPLE START POINT is controlled in two ranges. Refer to pg. 27 for
explanation of the ranges.
Sample Stop Point
: Determines the point at which the sample stops playing. This
Parameter can be used to eliminate unwanted sounds from the end of the sample. This
Parameter can be set at any point in the sample above the setting of SAMPLE START
POINT. Like the DELAY TIME Parameter of delay Modules, this Parameter is con-
trolled in two ranges. Refer to pg. 27 for explanation of the ranges.
Direct Level
: Sets the level of the dry (non-effected) sound. Variable from 1 to 100.
A M P L I T U D E
T I M E
INITIAL
SOUND
0 dB
-30 dB
REPEAT
HOLD
A M P L I T U D E
T I M E
INITIAL
SOUND
0 dB
-30 dB
29
Section 3 - Editing Effects
GSP-2101 Artist Owner’s Manual
Editing Effects