Masthead Amplifier LT-3276 User Manual
IMPORTANT SAFETY INSTRUCTIONS WARNING: Risk of fire and shock Use only power inserter and power supply in dry locations. This is for indoor use only. Feature: This HDTV Antenna Amplifier is specially designed for digital TV broadcast reception. It improves antenna reception by amplifying weak signals and helps overcome cable and splitter loss. This amplifier can be mast-mounted or wall-mounted outdoors or even used indoors.
cable specifications. RG-59 is the smaller one, RG-6U is the larger one. 2. Wiring the cable through the whole, make the connection. If using a pre-built cable (cable with connector on the end): 1. Cut the rubber boot as per picture ensuring it matches your cable specifications. RG-59 is the smaller one, RG-6U is the larger one. 2. After cutting the tube, you need to make a cross cutting on the remaining boot. It is recommended you keep 0.2 inches from th edge. 3. Wire the cable through the hole.
3. Connect the coax cable (not provided) from the OUTPUT on the amplifier to the ANTENNA input of the power inserter. When mast mounting, use the other larger zip tie provided to secure cable to mast. 4. When you want to wire the cable into your house, we recommended that you should have a water-drip loop before the cable into your house to prevent the water through the cable to your house. 5. Connect the coax cable pre-attached to the power inserter to the HDTV. 6.
8. Scan for channels on your HDTV. This step is very important. Your HDTV will not receive signals from your antenna without completing this step. See your TV’s menu for this process. You can also refer to the TV instruction manual for detail instructions. NOTE: It is important to repeat this process and re-scan for channels anytime you more or re-position your antenna.
Distributed by: TechBrands by Electus Distribution Pty. Ltd. 320 Victoria Rd, Rydalmere NSW 2116 Australia Ph: 1300 738 555 Int’l: +61 2 8832 3200 Fax: 1300 738 500 www.techbrands.