Owner’s Manual
IMPORTANT SAFETY INSTRUCTIONS WARNING FOR YOUR PROTECTION READ THE FOLLOWING: KEEP THESE INSTRUCTIONS HEED ALL WARNINGS The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit. The exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner’s manual.
IMPORTANT SAFETY INSTRUCTIONS ELECTROMAGNETIC COMPATIBILITY This device complies with part 15 of the FCC Rules and the Product Specifications noted on the Declaration of Conformity. Operation is subject to the following two conditions: • this device may not cause harmful interference, and • t his device must accept any interference received, including interference that may cause undesired operation. Operation of this unit within significant electromagnetic fields should be avoided.
WARRANTY We at DigiTech® are very proud of our products and back-up each one we sell with the following warranty: 1. Please register online at digitech.com within ten days of purchase to validate this warranty. This warranty is valid only in the United States. 2. DigiTech warrants this product, when purchased new from an authorized U.S. DigiTech dealer and used solely within the U.S., to be free from defects in materials and workmanship under normal use and service.
INTRODUCTION Thanks for choosing the DigiTech® Luxe polyphonic detune pedal – the world’s first stand-alone, compact detune pedal. Luxe takes the detune effect from the popular Whammy® and adds the ability to detune the signal either sharp or flat. Unlike chorus, detune does not modulate the slight pitch variance and adds a consistent “thickening” to the signal without the modulating side effects introduced by chorus.
1 USER INTERFACE 2 3 4 6 7 5 1 2 1. Power Connector 3 Connect the provided power adapter to this jack. Do not use any power adapter other than the one supplied. 2. Level Knob 4 6 7 Adjusts the mix of detune signal in with dry signal. 5 3. Detune Knob Selects detune range (+/- 50 cents). 4. Output Jack Connect this jack to the input of an amp, input of the next pedal on your pedalboard, or the effects return of an amp effects loop. 5. Input Jack Connect your instrument to this jack. 6.
CONNECTION DIAGRAM HARMAN PS0913DC POWER SUPPLY AMP OUT IN OTHER EFFECTS IN DISTORTION 3
SPECIFICATIONS Electronic Sample Rate: 44.1 kHz Frequency Response: 20 Hz-11 kHz (Effect Enabled) Signal to Noise Ratio: > -105 dB (A weighted); ref = max level, 22 kHz bandwidth THD: 0.
PHONE: (801) 566-8800 WEB: digitech.com SUPPORT: digitech.com/en-US/support Luxe Owner's Manual 5041404-A © 2014 Harman. All rights reserved. DigiTech is a registered trademark of Harman.
