User Manual

Time Signature

The JamMan Solo XT allows you to set a time signature before recording a loop. The

default time signature for empty loops is 4 beats per measure. Each time signature

setting represents how many beats are in the measure (i.e. a setting of 2 would

contain 2 beats per measure, a setting of 6 would contain 6 beats per measure, etc.).

Time signature can be adjusted from 2 to 15 beats per measure.

To set the Time Signature before recording a loop:

1. Select an empty memory location

using the <UP/DOWN> buttons

(LOOP and SINGLE LEDs will be off).

2. Press the <SETUP> button three

times, or until SIg appears in the

display.

3. Press the <UP> and <DOWN>

buttons to change the time signature.

4. Once the desired selection has been

made, press the <STORE> button

twice to store the changes before

recording your loop or press the

<PEDAL SWITCH> to exit the Setup

menu without storing.

NOTE: Whenever a tempo has been set, the TEMPO button LED will ﬂash red on the ﬁrst

downbeat of the measure and then green on the remaining beats of the measure. Time signature can

only be changed on empty loops. When accessing the time signature of a previously recorded loop,

the time signature will appear in the display, but it cannot be changed.