User Manual

39
Playing Back Loops Using JamSync
To initiate playback on synced JamSync devices:
1. Press the <PEDAL SWITCH> on any
slave device which you want to arm
for playback. The STATUS LED will
flash green, indicating the slave device
is armed for sync playback.
2. Press the <PEDAL SWITCH> on the
master device to initiate playback. The
master device will begin playing back
along with any slaved devices which
were armed for playback in step 1.
3. To then cue slaved devices for
playback, press the slave device’s
<PEDAL SWITCH> at any time
during master loop playback. The
STATUS LED will flash green,
indicating the slave device is cued for
sync playback. The slave device will
begin playing back the next time the
master device’s loop start point is
reached.
4. To stop loop playback of a slave
device, quickly press the <PEDAL
SWITCH>
twice.
5. To stop loop playback of all devices,
quickly press the master’s <PEDAL
SWITCH>
twice.