User Manual

Erasing All Loops (Internal Memory)

The JamMan Solo XT allows you to quickly erase all loops from internal memory.

WARNING! Erasure of all loops cannot be undone! You should backup any loops you wish to keep,

using the JamManager XT loop librarian management software, before erasing all loops.

To erase all loops from internal memory:

1. Ensure an internal memory location

has been selected (the CARD MEM

LED should be off). If the CARD MEM

LED is on, press and hold the <UP>

or DOWN> button until the LED

goes out.

2. Press and hold the <STORE> button

for approximately four seconds until

the display shows Eri (Erase Internal)

then release. The STORE button LED

will begin ﬂashing, waiting for erase

conﬁrmation.

3. Press the <STORE> button again. The

display will read E? (Erase Loops?).

4. To continue with the erasure of all

loops from internal memory, press

and hold the <STORE> button until

the display reads buS then release.

Wait for the JamMan Solo XT to

ﬁnish erasing all loops from internal

memory. To abort procedure, press

the <PEDAL SWITCH>.