Product specifications

10
Battery Operation
Intheeventthatbatterypoweriscompletelydepleted,HardWire
®
pedals
automaticallyswitchintobypass.Thiseliminatestheneedtoremovethe
pedalfromyourpedalchainifthebatteryisdead.Toreplacethebattery,do
thefollowing:
1. Usingthetipofa1/4”guitarcable,pushoneoftheReleasePinsinon
eithersideoftheFootSwitch,andremoveitfromthepedalchassis.
2. Removethebatteryfromthebatterycompartmentanddisconnectthe
batterycable.
3. Connectanewbatterytothebatterycableandputitbackinthebat-
terycompartment.Makesurethebatterycabledoesnotinterferewith
thespringorpedalswitcharm.
4. PlaceoneholeoftheFootSwitchoveritscorrespondingpin.
5. PushtheoppositepininandlowertheothersideoftheFootSwitch
intoplaceoverthedepressedpin.Releasethepin.WhentheFoot