User Guide

Digital Output Level
This menu allows you to adjust the signal strength at the S/PDIF Digital Output.This is useful in getting enough level
into a digital mixer or recorder.The procedure for selecting and adjusting the Digital Output Level is as follows:
1.Press the AMP SAVE and STORE buttons simultaneously. Both buttons will light indicating you are in the Utilities.
2.Press the TAP-IT or EDIT buttons until DIGLVL shows in the display.
3.Rotate the DATA knob to select the desired Digital Output Level (1-20).
4.Press the AMP SAVE and STORE buttons simultaneously again to exit.
Dry Track
The Dry Track feature is useful for recording dry guitar tracks with the intent of adding processing after the tracks have
been recorded.All effects can be monitored through the analog left/right and headphone outputs when Dry Track is
enabled. With Dry Track 1 enabled, the signal delivered to the Digital Output signal includes processing from the
Pickup Modeling module through the Noise Gate module. With Dry Track 2 enabled, the signal is tapped of the input
jack and sent directly to the digital output. This lets you record an unprocessed signal that can be fed back into the
input for the purpose of ‘re-amping’ your signal through different amp models. If Dry Track is disabled, the signal is
tapped off after all effects (same as the analog outputs).To access the Dry Track option:
1.Press the AMP SAVE and STORE buttons simultaneously. Both buttons will light indicating you are in the Utilities.
2.Press the TAP-IT or EDIT buttons until DRYTRK shows in the display.
3.Rotate the DATA knob to select OF (disabled), 1 (Dry Track 1), or 2 (Dry Track 2).
4.Press the AMP SAVE and STORE buttons simultaneously again to exit.
Factory Reset
The Factory Reset procedure is used to restore the Genesis3 to it’s original Factory settings.This procedure will erase
all user programmed Presets,and Utility settings.The procedure for performing a Factory Reset is as follows:
NOTE: Performing this function will erase all user-programmed data.All such data will be lost forever! Be sure
you want to erase the memory and start fresh before continuing with this procedure.
1.Disable the DigiTech Control X foot controller (if connected) by switching the FC/MIDI switch on the rear panel to
the MIDI position.
2.Press the AMP SAVE and STORE buttons simultaneously. Both buttons will light green indicating you are in the
Utilities.
3.Press the TAP-IT or EDIT buttons until the alpha-numeric Display shows RESET (Reset).
4.Press the flashing STORE button.The display reads NO Yes (No Yes) and the NO is blinking.
5.Press the STORE button while the no is blinking in the display to abort the Reset procedure.
6.If you are sure that you want to reset all user settings,press the EDIT button until the word YES begins blinking in
the display.
7.Pressing the STORE button will reset the Genesis3.The display will return to the Reset screen
8.Press the AMP SAVE and STORE buttons simultaneously again to return to the Genesis3 Presets.
Other Functions
36