User Guide

Select and Adjust the Reverb
In our example Preset we also wanted a little bit of Hall Reverb to provide some ambience.Press the EDIT button
again and the Reverb LED will light.If the Display indicates that the Reverb is off (ReVeRBOF),rotate the DATA knob
until the Display reads REVERBOn (Reverb On).Rotate the P1 knob to select HALL (Hall) as the Reverb Type.Rotate
the P2 knob to set the Reverb Predelay to a value of 2. Rotate the P3 knob to set the Reverb Decay to a value of 15.
Rotate the P4 knob to set the Reverb Damping to a value of 40. Rotate the P5 knob to set the Reverb Level to a
value of 30.
Store the Preset
The last step that we need to do is to store our changes to a User Preset.If we changed Presets or turned the
Genesis3 off without storing these settings,it would forget what we had done and revert back to the original Preset.
Press the STORE button once.The first letter in the Display begins to flash which is asking us to rename the Preset.
Since this is an example Preset,let’s name the Preset exampl.Rotate the DATA knob until the flashing character in
the Display is an E.Press the EDIT button and the second character begins to flash. Use the DATA knob again until
the flashing character is an X.Press the EDIT button again to Select the third character and change it to an A using
the DATA knob.Continue using the EDIT button to select the characters and the DATA knob to change the charac-
ters.
Once the Display reads exampL,press the STORE button again.Now the numbers in the red numeric display are
flashing,which is asking where to store this new preset.Rotate the DATA knob to select 48 as the destination. Press
the STORE button one more time to execute the Store function.
Congratulations! You have successfully created a preset.
Tutorial
27