User Guide

Adjust the Noise Gate
For our example,we wanted our Noise Gate to open quickly with a relatively weak signal.This type of gate would use
the Silencer™ with a low Threshold and short Attack Time.Press the EDIT button again and the Noise Gate LED will
light.If the Display indicates that the Noise Gate is off (GATE OF),rotate the DATA knob until the Display reads
GATE ON (Gate On).Rotate the P1 knob until the Display reads SILNCR (Silencer) as the type of gate.Rotate the
P2 knob to set the Threshold to a value of 20 (this may need further adjustment depending upon your guitar).Rotate
the P3 knob to set the Attack Time value to 0 (fast attack).
Select and Adjust the Chorus
Next we wanted to thicken up the sound in our Preset by adding a subtle Chorus effect.Press the EDIT button again
and the Mod/Pitch LED will light.If the Display indicates that this module is off (CHOMODOF),rotate the DATA knob
until the Display reads CHOMODon (Effect On).Then rotate the P1 knob until the Display shows CHORUS (Chorus) as
the effect type. Rotate the P2 knob to set the Chorus Speed to a value of 5. Rotate the P3 knob to set the Chorus
Depth to a value of 30. Rotate the P5 knob to set the Chorus Level to a value of 50.
Tu r n the Delay Off
In our example Preset we wanted the Delay to be bypassed.Press the EDIT button again and the Delay LED will light.
If the Display indicates that the Delay is on (DELAY ON),rotate the DATA knob until the Display reads DELAY OF
(Delay Off).
Tutorial
26