User Guide

IPS Amount - The P2 knob selects the Amount or interval of the shifted pitch.Interval choices include:
IPS Scale -The P3 knob selects the scale the IPS will use.Key choices include:MAJOR (Major), MINOR (minor),
DORIAN (Dorian),MIXLYD (Mixolydian),LYDIAN (Lydian),HARMIN (Harmonic minor).
IPS Key -The P4 knob selects the musical key the IPS will use.Key choices range from KEY E (Key E)
through KEY E (Key Eb).
Detuning is similar to a standard pitch shifter with the exception that it shifts the copied signal by less than a
semitone resulting in an effect as if two guitars were slightly out of tune and playing in unison.
Detune Amount -The P2 knob selects the AMNT (Amount) of detuning applied to the copied pitch in cents
(100 cents equals 1 semitone).Ranges from -24 (24 cents below) to +24 (24 cents above).
A Pitch Shifter will keep the shifted pitch at a parallel distance from the input note.
Pitch Interval -The P2 knob selects the SHIFT (Shift) of the pitch in semitone intervals. Ranges from -24
(two octaves below) to +24 (two octaves above).
Level -The P5 knob adjusts the Level or Mix (IPSLVL/IPSMIX) of all pitch altering effects in this module.
Ranges from 0 to 99.
Chorus/Mod Effects
The Modulation Effects row is a multi-function module allowing you to select effects such as;Chorus,Flanger,Phaser,
Triggered Flanger,Triggered Phaser,Tremolo, Panner,Vibrato,Rotary Speaker,AutoYa™, YaYa™, SynthTalk™, Envelope
Filter (auto wah),Detune, and Pitch Shift. Only one of the effects in this row can be used at a time.The following pages
describe each Effect and their Parameters in more detail.
On/Off -The DATA knob is used to turn the Chorus/Mod module on and off.
Type -The P1 knob is used select the type of Effect to be used in the Effect module. After selecting the type of
effect,the P2, P3, P4, and P5 knobs adjust the individual Parameters associated with the selected effect.
Chorus (CHORUS)
A Chorus adds a short delay to your signal.The delayed signal is modulated in and out of tune and then mixed back
with the original signal to create a thicker sound.
Speed -The P2 knob adjusts the rate (SPEED) of the modulation. Ranges from 1 to 99.
Depth -The P3 knob adjusts the intensity (DEPTH) of the modulation. Ranges from 1 to 99.
PreDelay -The P4 knob adjusts the PreDelay (PREDLY) or length of time before the Chorus effect is applied to
the input signal.Ranges from 1 to 20.
* Waveform - Selects the waveform used by the Chorus.Waveforms include Triangle,Sine,and Square.
* Balance -Adjusts the left to right balance of the wet signal.Ranges from L 99 to R 99.
Mod Level -The P5 knob controls the volume of the Chorus.Ranges from 0 to 99.
Flange (FLANGE)
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds regeneration (or repeats) to
the modulating delay.This results in an exaggerated up and down sweeping motion to the effect.
Speed -The P2 knob adjusts the rate (SPEED) of the modulation. Ranges from 1 to 99.
Depth -The P3 knob adjusts the intensity (DEPTH) of the Modulation. Ranges from 1 to 99.
Feedback -The P4 knob adjusts the amount of feedback (REGEN) added to the Flanger delay.Ranges from 0 to
99.
* Waveform- Selects the waveform used by the Flanger.Waveforms include Triangle,Sine,and Square.
* Balance - Adjusts the left to right balance of the wet signal.Ranges from L 99 to R 99.
Mod Mix -The P5 knob controls the mix of wet and dry signal.Ranges from 0 (all dry) to 99 (all wet).
* These Parameters are only available using the G
ENEDIT™ computer editor software.
OCTDN (octave down)
7THDN (a seventh below)
6tHDN (a sixth below)
5tHDN (a fifth below)
4tHDN (a fourth below)
3RDDN (a third below)
2NDDN (a second below)
2NDUP (a second above)
3RDUP (a third above)
4THUP (a fourth above)
5THUP (a fifth above)
6THUP (a sixth above)
7THUP (a seventh above)
OCTUP (an octave above)
Effects
17