User Guide

Editing Amp Models and Cabinet Types

Each Preset in the Genesis3 is equipped with a Green, Red,and Yellow (Warped) Amp Channel.The Green and Red

Amp Channels include individually assignable Amp Models, Cabinet Types, Gain,EQ, and Level settings.Each Green and

Red Cabinet can also be tuned,meaning that you can select the Cabinet’s resonant frequency. Once these Parameters

have been adjusted,the characteristics selected for the Green and Red channels can then be Warped together resulting

in a completely new HyperModel™.

Selecting the Amp/Cabinet Models

The procedure for selecting an Amp or Cabinet Model for the Green and Red Channels is as follows:

1.Press the WARP knob to select the Green Channel indicated by the LEDs next to the Amp Parameter knobs

lighting green.

2.Rotate the AMP MODEL knob to select the Green Amp Model.As the knob is rotated,a green LED will indicate

the selected Amp Model and the Amp name will appear in the alpha-numeric Display. See the Amp/Cabinet

Modeling section on page 9 for a complete list of Amp Models.

3.Rotate the CABINET knob to select the Green Cabinet Model.As the knob is rotated,a green LED will indicate

the selected Cabinet Model and the Cabinet name will appear in the alpha-numeric Display. See the Amp/Cabinet

Modeling section on page 9 for a complete list of Cabinet Models.

4.Press the WARP knob again until all Amp Parameter LEDs turn Red indicating that the Amp Parameters for the

Red Channel have been accessed.Then repeat steps 2 and 3 for selecting the Red Channel Amp and Cabinet

Models.

Adjusting the Amp Parameters

The Gain,EQ, and Level Parameters can be adjusted individually for the Green and Red Amp Channels.The Gain

ranges from 0 (0) to 99 (99).The Bass,Mid,and Treble EQ range from -12 (-12 dB) to 12 (+12 dB).The Level

ranges from 0 (0) to 99 (99).The procedure for adjusting the Amp Parameters is as follows:

1.Press the WARP knob until all Amp Parameter LEDs light green.This indicates that you have accessed the Amp

Parameters for the Green Channel.

2.Rotate the GAIN knob to adjust the distortion drive for the Green Amp Channel.

3.Rotate the BASS knob to adjust the low frequency enhancement for the Green Amp Channel.

4.Rotate the MID knob to adjust the Mid range frequency enhancement for the Green Amp Channel.

5.Rotate the TREBLE knob to adjust the high frequency enhancement for the Green Amp Channel.

6.Rotate the LEVEL knob to adjust the volume for the Green Amp Channel.

7.Press the WARP knob again until all Amp Parameter LEDs turn Red indicating that the Amp Parameters for the

Red Channel have been accessed.Then repeat steps 2 through 6 for adjusting the Red Amp Channel.

Editing Functions