User`s guide

3 - 2 Operating Instructions

DigiGate-700

for Windows

™ ®

Introduction

This section deals with the operation of the DigiGate-700 for Windows program. The Setup button of the

Main Menu

was covered in Chapter 2. This chapter covers the other 12 buttons on the

Main Menu

provide a step by step guide of every operation in the program. This is the complete reference for normal use

of the program. Once you have become familiar with the DigiGate-700 for Windows program, you can find

a quick reference to the different operations in “Chapter 4, How Do I ...?”

If you have more than one site controlled by this software system, always

verify that you are connected to the correct site before manipulating tenants

or units. You can quickly locate this information in the center block of the

status bar at the bottom of the Main Menu.

1. From the

Main Menu

, Click on the

Move In

button. Figure 3-1.

2. This will open the

Select Unit to Move In

screen. Figure 3-2.

3. Enter a valid unit number in the

Unit Number

field and Click on the

button to open the

Move In Tenant

window shown in Figure 3-5,

Page 3-4.

If you want to find a vacant unit of the right

size, Click on the

Size

field.

Figure 3-1

Figure 3-2

Move In (Renting a Unit)

Selecting a Unit