User Manual

Owner's Manual
7
Connection Diagrams
Cable Diagrams
Stereo Connection to Live FX Aux In
1/8” Stereo Cable
Left
Channel (+)
Right
Channel (+)
Ground
Left
Channel
Right
Channel
Ground
Ground
Left +
Left +
Right +
Right +
Ground
Use a cable like this when connecting a stereo 1/4" feed to the Live FX's Aux In jack.
NOTE: You can also use the above cable when connecting a mono signal to the
Aux In jack–such as when connecting an aux send or direct output from the
mixing console. This type of connection could be used to send a "guitar only"
signal to the Live FX for use with Live Adapt. Simply use only one of the 1/4"
plugs and leave the other disconnected.
Stereo Connection from Live FX Line Out
1/4” Stereo Cable
Left
Channel (+)
Right
Channel (+)
Ground
Ground
Left +
Right +
Left
Channel
Right
Channel
Ground
Left +
Right +
Ground
Use a cable like this to connect the Live FX's 1/4" Headphone/Line Output to the
1/4" line inputs of another device.
NOTE: Connecting a mono TS cable to the 1/4" stereo Headphone/Line Output
jack is not recommended. If you require a single mono feed from the 1/4" stereo
Headphone/Line Output, it is recommended that you use a stereo cable as shown
above and use only one of the TS plugs, leaving the other disconnected. You will
then need to turn STEREO mode off in the System Edit menu (see "Stereo" on
page 29).