User Manual

16
EQ
The EQ parameters allow the tone of the incoming vocal to be adjusted as indicated
by the table below. This function cannot be entirely bypassed via a single parameter,
instead the Low Cut must be turned OFF and the remaining gains (dB Bass, dB
Mid Gain, dB Treble) must be set to 0 dB to bypass this feature.
Low Cut
Locut off
Locut xxxhz
Low cut feature is turned off.
All frequencies below xxx Hertz are
attenuated.
Range: 60Hz – 120Hz
Bass
Db bass
Reduces or increases the volume of
bass frequencies.
Range: -12dB to 12dB
Mid Gain
Db mid
Reduces or increases the volume of
midrange frequencies. Range: -12dB to
12dB
Mid Frequency
Midfxxxxhz
Selects the frequency (xxxx) that is
reduced or increased with Mid Gain.
Range: 80Hz – 7650Hz
Treble
Db treble
Reduces or increases the volume of the
treble frequencies. Range: -12dB to 12
dB