User Manual

13
4. Change the Preset Name (if desired). To change the preset name:
• Turn the second Parameter knob to select a letter in the Alphanumeric
display (or use the Key Up/Down buttons). The selected letter will ash.
• Turn the third Parameter Knob to change the selected letter.
5. Press the Store button again to save your settings (or press any button other
than Store to cancel).
Note: There are two kinds of presets: User and Factory. You can change User
presets (numbers 1A/B-50A/B), but you can’t change Factory presets (numbers
51A/B-00A/B). When the Vocalist
®
Live 5 ships from the factory, the User and
Factory presets are identical.
Warning: Do not disconnect the power from the Vocalist Live 5 when storing a
preset (when the Alphanumeric display reads Storing...). Doing so may erase
your user presets. In the event that this happens, perform a Factory Reset, described
on page 26.
Copying Presets
The Vocalist Live 5 allows you to copy the A part to both A and B parts and vice
versa. This can be helpful when making massive changes to a preset and you want it
copied to both parts.
To copy the A or B part to both parts:
1. Follow Steps 1-4 for storing a preset above.
2. Press the A/B footswitch or button (Display shows STOR A AB,
STOR B AB, depending on which part was selected when you pressed Store).
Press the A/B Footswitch again to select STOR AB AB.
3. STOR A AB will store Part A settings to both Part A and B.
4. STOR B AB will store Part B settings to both Part A and B.
5. STOR AB AB will store Parts A and B to Parts A and B.
6. Press the Store button again to copy the preset to both parts (or press any
button other than Store to cancel).