User Manual
Table Of Contents
- Introduction
- Features
- Included Items
- User Interface & Connectors
- Connection Diagrams
- Quick Start
- Operation
- Selecting a Loop in Memory
- Free-Form vs Auto Quantized Looping
- Recording a Loop (Free-Form)
- Recording a Loop Using Auto Record
- Recording a Loop (Auto Quantize)
- Recording a Loop Using Pedal Tempo (Auto Quantize)
- Recording a Loop Using the AUX IN Jack
- Multiple Loop Playback (Cueing Loops)
- Recording Overdubs
- Undo, Redo, & Clear
- Time Stretching a Phrase
- Storing a Loop
- Copying a Loop
- Deleting a Loop
- Erasing All Loops (Internal Memory)
- Erasing All Loops (External Memory Card)
- Using JamSync
- Setup
- External Micro SD/SDHC Memory Cards
- JamManager XT Librarian Software
- Optional FS3X Footswitch
- Factory Restore
- Specifications
53
Formatting Memory Cards
If a memory card is inserted into the JamMan Solo XT that does not have a valid
format, the JamMan Solo XT will not recognize it and the display will read nF. The
card must be formatted before the JamMan Solo XT can use it.
It is recommended any memory card that is inserted into the JamMan Solo XT for
the first time be formatted using the JamMan Solo XT’s format procedure.
WARNING! Formatting a memory card will erase all data on the card.
To format a Micro SD/SDHC card when “nF“ is displayed:
1. While the display reads nF, the
STORE button will begin flashing
prompting for a format confirmation.
2. Press the <STORE> button. The
display will read F? (Format ?) and the
STORE button will continue to flash.
If you wish to abort this procedure,
press the <PEDAL SWITCH>. If you
wish to proceed, go to step 3.
3. To initiate the card formatting
procedure, press and hold the
<STORE> button for two seconds.
The display will show BuS indicating
the card is being formatted. Once
completed, the JamMan Solo XT will
return to normal operation.