User Manual
Table Of Contents
- Introduction
- Features
- Included Items
- User Interface & Connectors
- Connection Diagrams
- Quick Start
- Operation
- Selecting a Loop in Memory
- Free-Form vs Auto Quantized Looping
- Recording a Loop (Free-Form)
- Recording a Loop Using Auto Record
- Recording a Loop (Auto Quantize)
- Recording a Loop Using Pedal Tempo (Auto Quantize)
- Recording a Loop Using the AUX IN Jack
- Multiple Loop Playback (Cueing Loops)
- Recording Overdubs
- Undo, Redo, & Clear
- Time Stretching a Phrase
- Storing a Loop
- Copying a Loop
- Deleting a Loop
- Erasing All Loops (Internal Memory)
- Erasing All Loops (External Memory Card)
- Using JamSync
- Setup
- External Micro SD/SDHC Memory Cards
- JamManager XT Librarian Software
- Optional FS3X Footswitch
- Factory Restore
- Specifications
30
Erasing All Loops (External Memory Card)
The JamMan Solo XT allows you to quickly erase all loops from external memory. The
erase procedure only erases JamMan Solo XT loop data. All other data and files on
the card are left untouched.
WARNING! Erasure of all loops cannot be undone! You should backup any loops you wish to keep,
using the JamManager XT loop librarian management software, before erasing all loops.
To erase all loops from the external memory card:
1. Ensure an external memory location
has been selected (the CARD MEM
LED should be on). If the CARD MEM
LED is off, press and hold the <UP> or
DOWN>
button until the LED lights.
2. Press and hold the <STORE> button
for approximately four seconds until
the display shows ErC (Erase Card)
then release. The STORE button LED
will begin flashing, waiting for erase
confirmation.
3. Press the <STORE> button again. The
display will read E? (Erase Loops?).
4. To continue with the erasure of all
loops from the external memory
card, press and hold the <STORE>
button until the display reads buS then
release. Wait for the JamMan Solo
XT to finish erasing all loops from
external memory. To abort procedure,
press the <PEDAL SWITCH>.