User Manual
Table Of Contents
- Introduction
- Features
- Included Items
- User Interface & Connectors
- Connection Diagrams
- Quick Start
- Operation
- Selecting a Loop in Memory
- Free-Form vs Auto Quantized Looping
- Recording a Loop (Free-Form)
- Recording a Loop Using Auto Record
- Recording a Loop (Auto Quantize)
- Recording a Loop Using Pedal Tempo (Auto Quantize)
- Recording a Loop Using the AUX IN Jack
- Multiple Loop Playback (Cueing Loops)
- Recording Overdubs
- Undo, Redo, & Clear
- Time Stretching a Phrase
- Storing a Loop
- Copying a Loop
- Deleting a Loop
- Erasing All Loops (Internal Memory)
- Erasing All Loops (External Memory Card)
- Using JamSync
- Setup
- External Micro SD/SDHC Memory Cards
- JamManager XT Librarian Software
- Optional FS3X Footswitch
- Factory Restore
- Specifications
29
Erasing All Loops (Internal Memory)
The JamMan Solo XT allows you to quickly erase all loops from internal memory.
WARNING! Erasure of all loops cannot be undone! You should backup any loops you wish to keep,
using the JamManager XT loop librarian management software, before erasing all loops.
To erase all loops from internal memory:
1. Ensure an internal memory location
has been selected (the CARD MEM
LED should be off). If the CARD MEM
LED is on, press and hold the <UP>
or DOWN> button until the LED
goes out.
2. Press and hold the <STORE> button
for approximately four seconds until
the display shows Eri (Erase Internal)
then release. The STORE button LED
will begin flashing, waiting for erase
confirmation.
3. Press the <STORE> button again. The
display will read E? (Erase Loops?).
4. To continue with the erasure of all
loops from internal memory, press
and hold the <STORE> button until
the display reads buS then release.
Wait for the JamMan Solo XT to
finish erasing all loops from internal
memory. To abort procedure, press
the <PEDAL SWITCH>.