User Manual
Table Of Contents
- Introduction
- Features
- Included Items
- User Interface & Connectors
- Connection Diagrams
- Quick Start
- Operation
- Selecting a Loop in Memory
- Free-Form vs Auto Quantized Looping
- Recording a Loop (Free-Form)
- Recording a Loop Using Auto Record
- Recording a Loop (Auto Quantize)
- Recording a Loop Using Pedal Tempo (Auto Quantize)
- Recording a Loop Using the AUX IN Jack
- Multiple Loop Playback (Cueing Loops)
- Recording Overdubs
- Undo, Redo, & Clear
- Time Stretching a Phrase
- Storing a Loop
- Copying a Loop
- Deleting a Loop
- Erasing All Loops (Internal Memory)
- Erasing All Loops (External Memory Card)
- Using JamSync
- Setup
- External Micro SD/SDHC Memory Cards
- JamManager XT Librarian Software
- Optional FS3X Footswitch
- Factory Restore
- Specifications
18
Recording a Loop Using Pedal Tempo (Auto Quantize)
See “Setup > Pedal Tempo” for information on enabling the Pedal Tempo feature.
1. Select an empty memory location
using the <UP/DOWN> buttons
(LOOP and SINGLE LEDs will be off).
2. Set the <RHYTHM LEVEL> control
to the 9 o’clock position.
3. Press the <PEDAL SWITCH> a few
times at the rate you want the phrase
tempo to be. You will begin to hear
the Rhythm Guide Track and the beats
will be indicated by a flashing TEMPO
button LED. Repeat this step to fine
tune the tempo, if necessary. When
using the Rhythm Guide Track, time
signature can be manually set to a
different time signature other than the
default of 4 beats per measure (see
“Setup > Time Signature”).
4. To exit Pedal Tempo Mode and
prepare for recording, press and
hold the <PEDAL SWITCH> until
the TEMPO button LED repeatedly
flashes yellow, then release.
5. Press the <PEDAL SWITCH> to
initiate recording. You will receive
a one bar count in, indicated by a
flashing red and green STATUS LED.
After the count in, begin playing with
the first beat to start recording.
Recording will be indicated by a solid
red STATUS LED.
6. As soon as you’re done recording,
press the <PEDAL SWITCH> again to
stop recording and initiate playback.
7. Quickly press the <PEDAL SWITCH>
twice to stop loop playback.
8. Press the <STORE> button twice if
you wish to store the loop.