User Manual
Table Of Contents
- Introduction
- Features
- Included Items
- User Interface & Connectors
- Connection Diagrams
- Quick Start
- Operation
- Selecting a Loop in Memory
- Free-Form vs Auto Quantized Looping
- Recording a Loop (Free-Form)
- Recording a Loop Using Auto Record
- Recording a Loop (Auto Quantize)
- Recording a Loop Using Pedal Tempo (Auto Quantize)
- Recording a Loop Using the AUX IN Jack
- Multiple Loop Playback (Cueing Loops)
- Recording Overdubs
- Undo, Redo, & Clear
- Time Stretching a Phrase
- Storing a Loop
- Copying a Loop
- Deleting a Loop
- Erasing All Loops (Internal Memory)
- Erasing All Loops (External Memory Card)
- Using JamSync
- Setup
- External Micro SD/SDHC Memory Cards
- JamManager XT Librarian Software
- Optional FS3X Footswitch
- Factory Restore
- Specifications
6
JAMSYNC
20
10 11 12
10. TEMPO BUTTON
Press this button multiple times to
set the tempo for a new loop or
change the tempo of a stored loop.
Beats are indicated by a flashing
red LED on the first downbeat and
flashing green LED on all remaining
beats of the measure. If the tempo of
a stored loop is changed, the loop
plays back at the new tempo without
any change of pitch. Pressing and
holding this button will reset any
tempo change applied to a loop (back
to its original tempo) as long as the
tempo change has not been stored
to memory.
11. SETUP BUTTON
Pressing this button will enter Setup
Mode where you can change global
parameters and loop attributes, such
as Rhythm Type, Time Signature, Pedal
Tempo on/off, etc. (see “Setup”).
12. STORE BUTTON
This button is used to store and copy
recorded loops and store changes to
loop attributes. Pressing and holding
this button will initiate the deletion
of the currently selected loop.