FOOT CONTROLLER USER’S GUIDE
DECLARATION OF CONFORMITY Manufacturer’s Name: Manufacturer’s Address: DigiTech 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product: Product name: Control X Product option: Control X powered by host unit.
Introduction Congratulations! You have expanded the capabilities of your GENETX™™ processor by purchasing the DigiTech Control X Foot Controller. The Control X is your key to getting the most out of your GENETX™ processor as it offers real time control over your sound. The Control X includes 8 footswitches, a 2 digit numeric display, tuning LEDs, and an expression pedal, all housed in a rugged steel chassis. Your DigiTech Control X was carefully assembled and packaged at the factory.
Front View 6 7 5 4 IN TUNE V-SWITCH AMP CHORUS/MOD A DELAY/(HOLD)TAP B BANK UP/(HOLD)TUNER C 3 BANK DOWN 1 2 1 3 2 1. Numbered Switches - Select presets within the selected bank on the GENETX™ processor. 2. Bank Down Switch - This switch is used to decrement through banks. 3. Expression Pedal - Adjusts the value of any parameters assigned to it in real time.The V-Switch feature will engage or disengage the wah effect, overriding the current pedal assignment. 4.
Rear Panel The rear panel of the Control X has one 5 pin DIN jack used to connect the Control X to the GENETX™ processor with the supplied 5 pin DIN cable. Connections Connecting the Control X to your GENETX™ Processor is very easy. Just follow these simple steps when connecting the Control X: 1. Begin with the power to your GENETX™ Processor turned off. 2.
Numbered Foot Switches The 3 numbered foot switches will access one of the three presets in the currently selected bank. Each of these switches has an LED directly above it to indicate the currently selected preset. Pressing the currently active Footswitch will bypass all effects in the GENETX™ processor, delivering a clean, unprocessed signal. Effect Foot Switches These switches correspond to the Amp Channel, Chorus/Mod, and Delay effects in the connected GeNetX™ processor.
2.When the display reads pf (pedal forward), rock the pedal forward to the toe down position and press the lit #1 footswitch on the Control X. 3.When the display reads pb (pedal back), rock the pedal back to the toe up position and press the lit #2 footswitch on the Control X. Note: If the display reads er, an error has occurred and steps 2 and 3 should be repeated. 4.The display now reads PS indicating that the GENETX™ processor is ready to set the sensitivity setting for the V-Switch.
760 South Sandy Parkway Sandy, Utah 84070 Telephone 801-566-8800 FAX 801-566-7005 International Distribution: 8760 South Sandy Parkway Sandy, Utah 84070 Telephone 801-566-8800 FAX 801-566-7005 DigiTech, GeNetX™, and CONTROL X are trademarks of Harman Music Group Copyright 2001 Harman Music Group Printed in the U.S.A. 6/01 Manufactured in the U.S.A. CONTROL X Manual 18-0445-A Please visit DigiTech on the World Wide Web at: http://www.digitech.
