A Harman International Company Control One Remote Foot Controller For use with the 2112 SGS, GSP-2101, Valve FX and Legend II Owner's Manual
Table Of Contents Safety Precautions.........................................................................................................................2 Warranty........ ...............................................................................................................................2 Quick Start....................................................................................................................................3 Introduction .................................................
Safety Precautions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN A T T E N T I O N : RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR W A R N I N G : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE The symbols shown at left are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit.
Quick Start and Introduction Quick Start For those of you who prefer to burn now and read later, we've included this Quick Start reference section to help you do it right the first time. Connect Cables: Make sure the power is off before connecting or disconnecting the cable to the Control One. Using a standard 5-pin DIN cable (MIDI-type), connect the Control One to the jack on the rear panel of the 2112 SGS, GSP-2101, Valve FX or Legend II where labeled FOOT CONTROLLER.
Section 1 - Startup Section 1 - Startup Front Panel Controls and Functions The front panel of the Control One consists of a 20 character vacuum-fluorescent display, ten programmable footswitches, a dedicated bypass footswitch, a Select switch, and the built-in continuous controller pedal. • Program Switches - Each programmable switch has a number (0-9) and can be programmed to function in one of several ways.
Section 2 - Basic Operation • Control Output - The Control Output is a 5-pin DIN connector (MIDI-type). All control information generated by the Control One is sent out the Control Output to the 2112 SGS, GSP-2101, Valve FX or Legend II. The Control One also gets its power from the 2112 SGS, GSP-2101, Valve FX or Legend II down this cable, eliminating the need for a separate power supply for the foot controller.
Section 3 - Programming the Control One Section 3 - Programming the Control One All programming and setup for the Control One is performed from the front panel of the 2112 SGS, GSP-2101, Valve FX or Legend II. Most of the setup menus that deal with the Control One can be found in the Foot Controller section of the Utility setup menu.
760 South Sandy Parkway Sandy, Utah, 84070 Telephone (801) 566-8800 FAX (801) 566-7005 International Distribution: 3 Overlook Drive Unit 4 Amherst, New Hampshire 03031 U.S.A. FAX (603) 672-4246 DigiTech™is a registered trademark of DOD Electronics Corporation Copyright © 1997 Digitech Electronics Corporation Printed In U.S.A. 5/97 Manufactured in the U.S.A.
