DECLARATION OF CONFORMITY Manufacturer’s Name: Manufacturer’s Address: DigiTech 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product: Warning For your protection, please read the following: Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. Product option: all (requires Class II power 3. Heed all warnings. adapter that conforms to the 4. Do not use this apparatus near water. requirements of EN60065, 5. Clean only with dry cloth.
WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1.The warranty registration card must be mailed within ten days after purchase date to validate this warranty. 2. DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service. 3.
The Metal Master is the world’s most advanced heavy metal distortion pedal. DigiTech’s exclusive AudioDNA™ technology is what makes the Metal Master more than your standard distortion stompbox. Rather than working from a single distortion type circuit with tone controls, the Metal Master features a Morph knob which blends between three totally different metal distortion types. This gives you a wide variety of different metal distortion sounds that can be dialed in quickly and easily. 1.
1 2 3 4 5 11 10 9 6 7 8
4. High Knob Controls the boost or cut of high frequencies. Turn this knob clockwise to increase the high frequency content, and counter-clockwise to decrease the high frequency content. 5. Morph Knob Morphs between the three different metal distortion voicings. The minimum position is a smooth high gain tone. The 12 o’clock position is a scooped midrange sound. The maximum position is a punchy mid range heavy metal sound that really cuts through the mix.
. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these pins in to release the pedal from the chassis exposing the battery compartment. (See battery replacement diagram.) 8. Pedal Press the pedal to turn the effect on and off. 9. Out 1(Amp) Jack Connect this output to your guitar amplifier. 10. Indicator LED This LED indicates when the effect is turned on. If the LED becomes dim or does not light when the cables are connected, the battery needs to be replaced.
Connections The Metal Master has a single input (INPUT) and a pair of outputs (AMP and MIXER). The two outputs give you the following options: running into a guitar amplifier, running directly to a mixing console or recording device, or both. The MIXER output uses DigiTech’s advance CIT™ cabinet modeling technology for an authentic guitar amplifier sound without using an amp. Follow these setup directions before use: 1.Turn the volume down on the amplifier/mixer you are connecting to. 2.
Battery Replacement 1. Using the tip of a 1/4” guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. 2. Remove the battery from the battery compartment and disconnect the battery cable. 3. Connect a new battery to the battery cable and put it back in the battery compartment. Make sure the battery cable does not interfere with the spring or pedal switch arm. 4. Place one hole of the pedal over its corresponding pin. 5.
SPECIFICATIONS: • Controls - Level, Low, High, Morph, On/Off Pedal • Jacks - Input, Normal Out, Mixer Out • Input Impedance - 1 MOhms • Output Impedance - 100 Ohms • Power Supply - 9V Alkaline Dry Battery • Power Consumption - 4.8Watts (w/optional PS200R power supply) • Battery Life - Approximately 4 hours (with continuous usage) • Dimensions - 4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H) • Weight - 1.38 lbs.
