User Manual
35
Expression Pedal Calibration
The Expression Pedal on the RP90 needs to be recalibrated for use after a factory reset has been
performed. This calibration procedure is automatically entered after a factory reset procedure.
(You can also initiate the calibration procedure by pressing and holding both Footswitches for
approximately 5 seconds.) In the event the Pedal’s calibration fails, or if the Pedal does not function
properly, it can be re-calibrated using the Pedal Calibration procedure. This will not erase the
User presets. The procedure for Calibrating the Expression Pedal is as follows:
Press and hold the Up/Down Footswitches until appears in the display ( and
will be displayed before is shown). Release the Footswitches at this time.
When the Display prompts you with , rock the Expression Pedal forward (toe down)
and press either Footswitch.
When the Display prompts you with , rock the Expression Pedal back (heel down)
and press either Footswitch.
If calibration is successful, will appear briefly in the Display and the RP90 will return
to Performance mode. If the calibration procedure fails, will appear in the Display fol-
lowed by . Steps 2 and 3 should be repeated until calibration is successful.
Press and hold the Up/Down Footswitches until and then appears in the Display
( and will be displayed before is shown). Release the footswitches at this time.
1.
2.
3.
4.
5.