Specifications

57
DCS-3950 series Ethernet switch manual
interface ethernet 0/0/3
enable
show flash
show ftp
5.2.5.6 show memory
Command：show memory
Function：Display the contents in the memory
Command mode: Admin Mode
Usage Guide: This command is used for debugging purpose. Base memory address and
length can be entered through interactive way. The information given by the system falls in
to three parts, which are the addresses, memory dump in lexical words, and the
corresponding ASCII characters.
Example:
Switch#show memory
start address : 0x2100
number of words[64]:
002100: 0000 0000 0000 0000 0000 0000 0000 0000 *................*
002110: 0000 0000 0000 0000 0000 0000 0000 0000 *................*
002120: 0000 0000 0000 0000 0000 0000 0000 0000 *................*
002130: 0000 0000 0000 0000 0000 0000 0000 0000 *................*
002140: 0000 0000 0000 0000 0000 0000 0000 0000 *................*
002150: 0000 0000 0000 0000 0000 0000 0000 0000 *................*
002160: 0000 0000 0000 0000 0000 0000 0000 0000 *................*
002170: 0000 0000 0000 0000 0000 0000 0000 0000 *................*
5.2.5.7 show rom
Command：show rom
Function：Display enabled document and bulk
Command mode: Admin Mode
Example: To show the information about bootup file.
Switch#sh rom
file name file length
nos.rom 170992 bytes
5.2.5.8 show running-config
Command: show running-config
Function: Display the current active configuration parameters for the switch.
Default: If the active configuration parameters are the same as the default operating
parameters, nothing will be displayed.