Installation Instructions

45 DVB-S Receiver
GB
6.5 Software Upgrade
When you enter to “Software Upgrade”
menu, you will see a screen like beside:
1. Press [CH
] to select the wanted
item among Software Upgrade and
Upgrade by Satellite.
2. Press [OK] to enter the selected item.
6.5.1 Software Upgrade
1. This function allows you to upgrade the
software of the receiver. This can be done
from PC to receiver or from a master
receiver to a slave receiver.
2. Connect master receiver or PC to the
slave receiver via serial interface
(0-Modem cable). Enter the “Software
Upgrade” menu of the master receiver
and press [Vol ], to change the upgrade
mode. Upgrade modes include: All code/
Main code/CAS-data/Script GUI/Radio Back/default DB/Userdb.
3. Switch on the slave receiver.
4. Mark “Start” on the master reeciver and press [OK] to start upgrade.
Wait until the display on the front panel shows “-END”. Then switch off the receiver
and on again. Now the new software is used.
5. Press [MENU] to save the setting without upgrade.
6. TOOLS
BDA Imperial DB 2_GB_TO.indd 45BDA Imperial DB 2_GB_TO.indd 45 15.10.2008 13:47:07 Uhr15.10.2008 13:47:07 Uhr