Installation Instructions

44
Installation Guide
GB
3. Once the fi le has been loaded, it requires the conformity to end the upgrading
process, writing into the receiver “Are you sure to burn fl ash ?”. Press [OK] to up-
grade the receiver. In case during the reading of the fi le, it is corrupted or it would be
a not appropriated for this model of receiver, an alert message would appear “Error
reading the USB disk”.
4. After pressing [OK] the receiver will write into the Flash memory, and it will reboot to
end the upgrading process.
NOTE:
1. USB Upgrade menu will be gray when no USB device is pluged.
2. The upgrade fi le is the binary fi le, *.bin. Only the fi les, which extend name is bin,
would be displayed. User need put the upgrade fi le under root of USB card.
6.6 SatcoDX Auto Programming
This function is using the tables of the SatcoDX websites to update your channel and
satellite lists. You need a special application which is available on
the CD-ROM of the Tele-Satellite magazine. Install this software on your PC fi rst.
1. Start the SatcoDX application on your PC.
2. Select “SatcoDX Auto Programming” item from the “Tools” menu and press [OK].
The screen will show the message “OK to Proceed”.
3. Press [OK] again and you will see the message “Ready to Download”.
4. In the PC application set the Baud Rate to 115200 and start the download
procedure.
! Caution:
The new download channels will delete the original channels list. Please be careful
before using it.
6. TOOLS