Installation Instructions

38
Installation Guide
GB
5.6 Power setting
When you select this option, you will see a
screen like beside:
LNB Power: If your receiver is connected
to the LNB directly then you need to set
the LNB Power to “On”. If your receiver is
connected to a multi switch (SMATV signal
distribution system) then it may be that you
don’t need to provide the power to the LNB.
But since this is depending on the kind of
installed distribution system we recommend
you to contact your installer or to refer to
the user manual of this system to get the
correct information.
You also just can change this setting and
check if you still can receive the channels. If
the LNB Power is off and you still can see all
channels then we recommend this setting.
5. SYSTEM SETUP