Installation Instructions

29 DVB-S Receiver

• When you press [Red] it will display “New TP” in “TP Index” item. You have to set the

parameters of “TP Frequency”, “Symbol Rate” for this new transponder. Therefore

use the number buttons of the RCU. The available range are “3000~13450MHz” and

“1000~45000KS/s”.

• When you press [Green] a safety question will be displayed for conﬁ rmation to delete

the current transponder or not. If you select “OK”, the current transponder will be

deleted and the total number of transponders will be reduced.

• When you press [Yellow] a safety question will be displayed for conﬁ rmation to delete

all transponders or not. If you select “OK”, the all transponders on current satellite will

be deleted.

3. For existing transponders you also can use number buttons to modify the param-

eters of “TP Frequency” and “Symbol Rate” or [Vol ] to change the value directly.

“Polarity” and “FTA only” are used for setting scans conditions. Press [Vol ] to

select a different mode.

On “TP Scan” item, press [OK] will open another window where you can set “Scan

Mode”, “Program Type” and “NIT Search”. Press [Menu/Exit] to return to the

previous menu.

Press [Red] button to add a new TP.

Press [Green] button to delete the current TP.

Press [Yellow] button to delete all transponders on current satellite

4. Antenna Setup: Press [OK] to enter LNB

conﬁ guration, you will see a window like

beside:

LNB Type:

Press [Vol ] to switch among “Stand-

ard”, “User” and “Universal” mode.

For Example: If you use a Dual LNB, then

you should select “User” option in “LNB

Type” and set the correct frequency in

LNB type.

22K: Use [Vol ] to switch “ON” and “Off”. The 22KHz signal is used in KU universal

LNBs to change between low band and high band.

! Notice:

After choosing LNB type “Universal” you cannot modify 22K.

DiSEqC1.0:

Use [Vol ] to switch the options or press [OK] to open the DiSEqC1.0 option list to

select directly with[CH ] , press [OK] to conﬁ rm it.

4. INSTALLATION