Installation Instructions

23 DVB-S Receiver
GB
3.1.5 Find
1. Press [Blue] button to open the “Find”
window like showed beside. Press
[CH ] /[Vol ] to select the leading
character of the channel name and press
[OK] to confi rm it.
2. After entering the character(s) highlight
“OK” in the window and press [OK] on the
RCU.
3. Press [Exit] button to close the fi nd window and brings you back to the channel list.
3.2 Radio Channel List
Basically the operation of “Radio Channel List” is same as “TV Channel List”, except that
in the small channel window the radio Logo will be displayed.
3.3 Channel Setup
When you enter the “Channel Setup” menu
you will see a screen like beside:
1. Startup Channel: Press [OK] to enter
“Startup Channel” menu to see the screen
like showed beside
• If you set of “Boot on Channel” to “On”
you can edit the following two items. If
the setting is “Off” the box always starts
with the channel that was running when
the box has been switched off.
• On the “Mode” item you can select
either “TV channel” or “Radio channel”.
• On “Startup Channel” item you can open
the channel list by pressing [OK]. Then
you can select the channel of you
choice. Press [OK] again to confi rm.
2. Channel Play type: Use [CH ] to
select, press [OK] to enter “Channel Play
Type” menu. Here you can select the “play-
ing channels” as “All”, “Free” or “Scram-
bled” with [Vol ]
3. If you select “Free” then all scrambled
channels will be skipped when you change
channels with [Vol ]
4. Press [Exit] to leave the “Channel Setup”
menu.
3. CHANNEL