Installation Instructions

27 DVB-T Receiver

3. Load Default Timer Setting

When you enter “Load Default Timer Setting”,

you will see the window like right:

Press [OK] key on “Load Default Timer

Setting”, it will show “Input Password”

dialogue.

After you input the correct password, there

will show a warning message to inquiry you

“All Timers will be cleared, continue?”

If you select “Yes”, it will clear all the timer.

You can press [Exit] key to exit.

6.6 OSD Setting

When you enter to “OSD Setting” menu, you

will see a screen like right:

1. Subtitle Display: You can press [ /

] key to select “On” or “Off”. If the current

channel has subtitle information, it will be

showed up while this function is “On”. If

this function is “Off”, there won’t show up

subtitle information even if the current

channel has subtitle information.

2. OSD Timeout: When you switch channels

in full screen, there will show up some

information about current channel on the

lower of the screen. And regarding to the

duration of these information show up on

the screen, you can press [ / ] key to

switch the time. The range of the duration

is “1 second

10seconds”.

3. OSD Transparency: Besides the setting of “OSD Menu Style”, you also can set the trans-

parency of OSD. You can press [ / ] key to select the values. There are 9 levels of

transparency, 10%, 20%, 30%, 40% 50%, 60%, 70%, 80% and Off (means no trans-

parency function).

4. Load OSD Setting Default: If you are not satisfy with your setting, you can move highlight

to this item and press [OK] key to reset parameters as default value.

5. Press [Exit] key to exit the current menu.

6. SETUP