Operation Manual

29 DVB-S Receiver

4. Antenna Setup: Press [OK] to enter LNB conﬁguration, you will see a window like beside:

•LNB Type: Press [Vol ] to switch

among “Standard”, “User” and

“Universal” mode.

For Example: If you use a Dual LNB, then

you should select “User” option in “LNB

Type” and set the correct frequency in

LNB type.

•22K: Use [Vol ] to switch “ON” and

“Oﬀ”. The 22KHz signal is used in KU

universal LNBs to change between low

band and high band.

! Notice:

After choosing LNB type “Universal” you cannot modify 22K.

•DiSEqC1.0: Use [Vol ] to switch the options or press [OK] to open the DiSEqC1.0

option list to select directly with [CH ], press [OK] to conﬁrm it.

•DiSEqC1.1: Use [Vol ] to switch DiSEqC1.1 option or press [OK] to

enter DiSEqC1.1 option to select directly with [CH ], press [OK] to conﬁrm

it. The options of this item are: Disable/CCard1 M1 Port1/CCard1 M1 Port2/

CCard1 M1 Port3/CCard1 M1 Port4/CCard1 M2 Port1/CCard1 M2 Port2/

CCard1 M2 Port3/CCard1 M2 Port4/CCard1 M3 Port1/CCard1 M3

Port2/CCard1 M3 Port3/CCard1 M3 Port4/CCard2 Port1/CCard2 Port2/

CCard2 Port3/CCard2 Port4/CCard2 Port5/CCard2 Port6/CCard2

Port7/CCard2 Port8/CCard2 Port9/CCard2 Port10/CCard2 Port11/

CCard2 Port12/CCard2 Port13/CCard2 Port14/CCard2 Port15/

CCard2 Port16.

• Positioner: Press [Vol ] to select between “Oﬀ/DiSEqC1.2/USALS”.

! Notice:

When you select “DiSEqC1.2 or USALS”, “DiSEqC1.0” and “DiSEqC1.1” items will be

disabled.

• Polarity: Press [Vol ] to switch between “Auto/H/V ”.

• Toneburst: Press [Vol ] to switch this function “On” or “Oﬀ”.

5. After you completed your modiﬁcation, on the “TP Scan” item, press [OK] twice to start

scanning.

4. INSTALLATION