Operation Manual

38
Installation-Guide
GB
3. Channel Lock: If set to “Yes” then you need to enter the password before you can see
those channels which have been marked as locked channels in the channel menu. If set
to “No” then even those channels can be selected without entering the password first.
4. New Menu Password: Here you can change the existing password. You should do this
after you set up the receiver the first time and every time when you think that your
password is known by unauthorized persons. To change the password enter the new
password in the “New Menu Password” item and repeat the same one in the “Confirm
Password” item. If the passwords are not identically then you will see a warning mes-
sage. If you entered the same new password in both fields then you will see the message
“Saving Data, Please Wait…”. From now on you need to use the new password to open
locked menus or locked channels. NOTE: The default password is 0000.
5. Basically the operation of “New Chan(channel) Password” is same as “New Menu Pass-
word”.
6. Press [EXIT] to leave the “Parental Lock” menu.
5.6 POWER SETTING
When you select this option, you will see a
screen like beside:
1. Automatic Standby: press [OK] to open
the “Automatic Standby” menu. Automatic
Standby: Press [Vol◄/►] to select “Off”
and “On”. Time: Press [Vol◄/►] to select
“1hr” - “8hr”.
2. LNB Power: If your receiver is connected
to the LNB directly then you need to set
the LNB Power to “On”. If your receiver is
connected to a multi switch (SMATV signal
distribution system) then it may be that you
don’t need to provide the power to the LNB.
But since this is depending on the kind of in-
stalled distribution system we recommend
you to contact your installer or to refer
to the user manual of this system to get
the correct information. You also just can
change this setting and check if you still can
receive the channels. If the LNB Power is
off and you still can see all channels then
we recommend this setting.
3. Low Power Consumption: At this option, you could Enable / Disable the low power
consumption mode. This mode allows saving current consumption when the receiver
is stand-by. Low power consumption mode only can be enabled when the VCR Loop-
5. SYSTEM SETUP